Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Lets set the record straight...
View Single Post
Old July 24th, 2007, 08:58 AM   #13
Can't lose with 42s
Cartman's Avatar
Join Date: 08-17-06
Location: Williamsburg, MI
Posts: 1,050
iTrader: (6)
Mentioned: 0 Post(s)

Originally Posted by 95geo View Post
you need to check how far your shafts can turn without binding, you can do this on the jack stands and a paint pen. just turn the wheel from lock to lock and spin the tires, adjust the stops on the knuckles until there is sufficient clearance in the yokes of the shafts.

you friends probably say the tubes are too thin because they are running them on an 8k lbs truck with 44" ground hogs.

for what its worth i bent a rear dana 44 with 1/4" tubes... lots of factors had to do with it though, not just "thin wall tubes"
Yeah thats a very good idea.... I was planning on doing that but can't frickin stand it when the tires rub on the radius arms...I could adjust the knuckles for that I spose, but the tighter turning radius would be kickass
Cartman is offline   Reply With Quote
Page generated in 0.11144 seconds with 22 queries