Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Lets set the record straight...
View Single Post
Old July 24th, 2007, 08:55 AM   #12
95geo
newbie
 
95geo's Avatar
 
Join Date: 11-05-05
Location: dryden
Posts: 5,776
iTrader: (6)
Mentioned: 0 Post(s)
Default

you need to check how far your shafts can turn without binding, you can do this on the jack stands and a paint pen. just turn the wheel from lock to lock and spin the tires, adjust the stops on the knuckles until there is sufficient clearance in the yokes of the shafts.

you friends probably say the tubes are too thin because they are running them on an 8k lbs truck with 44" ground hogs.

for what its worth i bent a rear dana 44 with 1/4" tubes... lots of factors had to do with it though, not just "thin wall tubes"
95geo is offline   Reply With Quote
 
Page generated in 0.05243 seconds with 20 queries