Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Ranger 2.3 Crankshaft timing sensor
View Single Post
Old July 6th, 2007, 10:35 PM   #1
In my parents basement
booblinker's Avatar
Join Date: 10-29-06
Location: Washington, mi
Posts: 12,179
iTrader: (5)
Mentioned: 20 Post(s)
Send a message via AIM to booblinker
Default Ranger 2.3 Crankshaft timing sensor

I have a 1990 ranger, it had some screwed up wiring on the cps. My first question is does the cps sensor being wired wrong cus the injectors not to fire. I fixed the wiring, other than the 5th wire the one without the coating, i dunno where that goes too. I know where it goes on the other side, but not the sensor side. If i can read the schematic right it should hood to the ground wire on the sensor.
booblinker is offline   Reply With Quote
Page generated in 0.06771 seconds with 22 queries