Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - '84 K30 - Bad Frame - Great Parts!
View Single Post
Old February 1st, 2006, 01:14 PM   #1
lt1yj
Senior Member
 
Join Date: 01-04-06
Location: Holland, Mi
Posts: 1,201
iTrader: (14)
Mentioned: 0 Post(s)
Default '84 K30 - Bad Frame - Great Parts!

'84 K30 350/th400/NP205 Dana 60/14 bolt 4:10 SRW clean title, located in Holland Mi.

This is an excellent truck to make into a heavy duty wheeling truck. It has all the sought after parts that everyone wants to move up to. Here's your chance to get it in one package. Fix it or part it.

The frame behind the rear spring front mount is rusty and is not useable as is. I do have a replacement frame section in good shape that could be welded in place vey easily that goes with the truck. Would be a good time to do a shorty wheeling truck.

The motor runs bad and burns oil. The trans has a very leaky pan (new) which I assume is just the gasket. The T case is the figure 8 pattern with a slip yoke. There is no bed on the truck. The cab needs corners and rockers but for a wheeling truck would be just fine. The doors close solidly and the interior is in pretty good shape. Tires are ok. Hydroboost setup in good shape. Good radiator, grill, hood, core support.

I want to sell the truck whole. If I part it out I'll keep the D60 and the 205.

$1600 or may consider tools or guns on trade.
lt1yj is offline   Reply With Quote
 
Page generated in 0.07275 seconds with 20 queries