Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My project TJ**pretty much finished**
View Single Post
Old April 4th, 2007, 01:34 PM   #85
Mall Rated
TJontherox's Avatar
Join Date: 06-14-06
Location: Sterling Hgts, MI
Posts: 1,492
iTrader: (8)
Mentioned: 1 Post(s)
Send a message via Yahoo to TJontherox

Got my shifter levers all mocked up now. A little bit of tweaking and it should be good to go. Bench testing it the t case binds up a bit, too hard for me to reach under the vehicle to turn the output and push a lever at the same time. It should work out good when it can run and drive, that way I can ease out on the cluch the get the t case gears to mesh and pop into gear.

When I get it all dialed in I will make some new levers. This was quick and easy to test it out.

Last edited by TJontherox; April 6th, 2007 at 12:47 PM.
TJontherox is offline   Reply With Quote
Page generated in 0.08108 seconds with 21 queries