Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Homemade Driveshaft Balancing Q's... JCR guys?
View Single Post
Old November 9th, 2005, 11:15 AM   #3
GMCsonoma94
1 wheel peel
 
GMCsonoma94's Avatar
 
Join Date: 11-06-05
Location: michigan
Posts: 1,577
iTrader: (0)
Mentioned: 0 Post(s)
Send a message via AIM to GMCsonoma94
Default

if you have a steel shaft drill and tap a hole in the shaft and pour half a gallon or so of antifreeze in the shaft and then put a pipe plug in. i guess you could do the same with an aluminum shaft if you welded a nut or somethin.
GMCsonoma94 is offline   Reply With Quote
 
Page generated in 0.05148 seconds with 20 queries