Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My project TJ**pretty much finished**
View Single Post
Old March 25th, 2007, 04:24 PM   #75
TJontherox
Mall Rated
 
TJontherox's Avatar
 
Join Date: 06-14-06
Location: Sterling Hgts, MI
Posts: 1,486
iTrader: (8)
Mentioned: 0 Post(s)
Send a message via Yahoo to TJontherox
Default

I finally got ahold of a 2" die for the bender this weekend to finish my cage and rear bumper. It only took about a month to track one down.


Nothing too exotic on the cage, but should hold up to a minor roll.




My cage mount will go on the end of the frame and be cut around the tube for the rear bumper.


There will be 2 tubes going forward to a cross member I welded in earlier to tie in the bumper from front to back. Then bump stops will also come off of those 2 tubes. I will also put on a couple shackle hangers for recovery

TJontherox is offline   Reply With Quote
 
Page generated in 0.05027 seconds with 20 queries