Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - setup tools
Thread: setup tools
View Single Post
Old March 1st, 2007, 03:04 PM   #11
GreenJeep8755
Senior Member
 
GreenJeep8755's Avatar
 
Join Date: 02-12-07
Location: Channahon, IL
Posts: 132
iTrader: (1)
Mentioned: 0 Post(s)
Default

inch pound torque wrench for setting pinion preload and side bearing preload.
dial indicator for measuring backlash when you are done, gear marking compound or prussian blue for checking gear pattern, then knowledge of adjusting pattern without messing up your preloads and backlash.....and most of all patience if it is your first time.....an extra crush sleeve or two would not hurt if it is that type of axle, and a press makes bearing removal and install easier, but not needed if you are really careful. hope this helps!
GreenJeep8755 is offline   Reply With Quote
 
Page generated in 0.05893 seconds with 20 queries