Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 05 F Series.. Seat belt alarm removal..
View Single Post
Old January 23rd, 2006, 10:00 AM   #24
Medic8
You call, we haul.
 
Medic8's Avatar
 
Join Date: 11-08-05
Location: Southgate, MI
Posts: 1,492
iTrader: (4)
Mentioned: 0 Post(s)
Default

Here is the actual procedure. ENJOY!

Read steps 1 - 9 before proceeding with the procedure.

The beltminder feature can be activated/deactivated by performing the following procedure.

BEFORE following the proceedure, make sure that:

-The parking brake is set.

-The gearshift is in P (park) (automatic) or in neutral position (manual transmission)

-The ignition switch if in the OFF position

-All vehicle doors are closed

-The drivers safety belt is UNBUCKLED.

-The parklamps/headlamps are in the OFF position (If vehicle is equipped with Autolamps, this will not affect the procedure)

1. Turn the engine switch to RUN (or ON) position (DO NOT START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1-2 minutes)
-Steps 3-5 must be completed within 60 seconds or the procedure will have to be repeated.

3. Buckle then unbuckle the safety belt 3 times, ending with the safety belt being unbuckled. Thsii can be done before or during BeltMinder warning activation

4. Turn ON the parklamps/headlamps, turn OFF the parklights/headlights

5. Buckle then unbuckle the safety belt 3 times, ending with the safety belt being unbuckled.

-After step 5 the safety belt warning light will be turned on for three (3) seconds

6. Within seven (7) seconds of the safety belt warning light turning off, buckle and unbuckle the safety belt

-This will disable BeltMinder if it is currently enabled, or enable BeltMinder if it is currently disabled.

7. Confirmation of disabling BeltMinder is provided by the safety belt warning light flashing four (4) times per second for three (3) seconds.

8. Confirmation of enabling Beltminder is provided by...

-The safety belt light flashing four (4) times per second for three (3) seconds

-Followed by three (3) seconds with the safety belt warning light off.

-Once again, the safety belt warning light will flash four (4) times per second for three (3) seconds.

9. After recieving confirmation, the deactivation/activation procedure is complete!!!
Medic8 is offline   Reply With Quote
 
Page generated in 0.05827 seconds with 20 queries