Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - ***hey axle guru's....a little help please***
View Single Post
Old February 27th, 2007, 04:20 PM   #2
Yetti
Buy a Fiat! Save the UAW!
 
Yetti's Avatar
 
Join Date: 11-05-05
Location: 20 minutes south of Hell...
Posts: 14,384
iTrader: (10)
Mentioned: 2 Post(s)
Default

if your talking about hub seals then there should be a spindle seal & thrust spacer that the stub shaft passes threw. it what seal out water to the spindle support bearing in the tube of the spindle. then there are hub seals on each side that keep water out of the back of the hub. do not run with out. aside from that the only other seals in the axle are inside the tubes on either side of the carrier. you must remove the carrier assem. to replace. they seal to the shafts where they come in the tube to the carrier.
__________________
Yetti
Yetti is offline   Reply With Quote
 
Page generated in 0.64535 seconds with 20 queries