Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - simple cheep tig rig you can make at home*now with pics*
View Single Post
Old February 26th, 2007, 07:19 PM   #17
co captain of cubes pants
sglide's Avatar
Join Date: 11-12-05
Location: kalkaska bitch
Posts: 4,117
iTrader: (1)
Mentioned: 1 Post(s)

Originally Posted by fittergirl View Post
That setup is very common for pipewelding in the field. Used on alot of stainless and chrome piping. That is all I saw at the refinery which is 100% x-ray.
one more= was it a full open root with back gassing? if it was how did they bead in with a mach strike without leaving an ark stike that will show on xray no matter how much you grind?
sglide is offline   Reply With Quote
Page generated in 0.12156 seconds with 22 queries