Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Dana 44- thick or thin? Master instal kit required?
View Single Post
Old February 15th, 2007, 03:45 PM   #20
Covered in mud...
Haggar's Avatar
Join Date: 11-06-05
Location: Oxford, MI
Posts: 17,916
iTrader: (59)
Mentioned: 9 Post(s)

Originally Posted by monkeyevil View Post
All Dana axles (seal face and bearing caps) are marked with a letter with a different orientation on both sides. Match the orientation of the letter on each side and your good.
I don't remember seeing them on my CJ axles, so I marked with a punch..

but, then again, I haven't ever worked on a dana axle made after 1974. My current Jeep doesn't have a dana 44, it has a Spicer 44..
Haggar is offline   Reply With Quote
Page generated in 0.11937 seconds with 22 queries