Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Dana 44- thick or thin? Master instal kit required?
View Single Post
Old February 15th, 2007, 02:41 PM   #16
Me balls are huge
FrankNBrew's Avatar
Join Date: 11-05-05
Location: Warren
Posts: 2,543
iTrader: (13)
Mentioned: 0 Post(s)

Originally Posted by gotsand? View Post
ok I am not an idiot, I just didnt mark the bearing caps when I took them off...all I was asking is does it matter which side of the diff they go back on with new bearings installed.

all of the write ups I see about marking the bearing caps had me worried for a minute. I will just carefully examine when I reassemble and be carefull not to F it up. I am sure there is some tell tale sign as to which one goes to which side and in what direction.

and I thought this might be good info for FrankNBrew too.

thanks for all your help guys

Thanks, but even a dumbass like me knows to mark the caps.
FrankNBrew is offline   Reply With Quote
Page generated in 0.17283 seconds with 22 queries