Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Dana 44- thick or thin? Master instal kit required?
View Single Post
Old February 15th, 2007, 01:05 PM   #8
sie sehen mich rollin ...
gotsand?'s Avatar
Join Date: 05-04-06
Location: New Era, MI --- "We passed BFE 35 minutes ago."
Posts: 3,334
iTrader: (11)
Mentioned: 0 Post(s)
Send a message via Yahoo to gotsand?

Originally Posted by Jeeperz Creeperz View Post
They're just like the main bearing caps on an engine. They're bored to fit only one way. The biggest risk is that by mixing them side to side or turning them around that you will crack/brake one when you torque it down.
so if they werent marked prior to removal, how would you figure out which one goes on which side?
gotsand? is offline   Reply With Quote
Page generated in 0.14464 seconds with 22 queries