Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - question about conrtol arm manufacturing?
View Single Post
Old February 8th, 2007, 02:32 PM   #4
95geo's Avatar
Join Date: 11-05-05
Location: dryden
Posts: 5,786
iTrader: (6)
Mentioned: 3 Post(s)

unless you have the steel laying there and your a cheap ass i wouldnt do solid steel ever.

1.75-2.0x.25-.5 for lowers 1.5-2.0x.12 wall for most uppers. if you want to be blingin go with 7075 solid aluminum tapped for the joints on the end.

square control arms usually look hillbilly.
95geo is offline   Reply With Quote
Page generated in 0.11681 seconds with 22 queries