Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 92 to 97 ranger motor swap, wiring help?
View Single Post
Old January 19th, 2007, 08:24 AM   #2
SinisterX
I Drank WHAT!
 
SinisterX's Avatar
 
Join Date: 01-14-07
Location: Owosso
Posts: 683
iTrader: (8)
Mentioned: 0 Post(s)
Send a message via MSN to SinisterX
Default

The 92 used the ignition module (gray box) and a 60pin PCM, in 97 the PCM controled the coils and has 104pins. Make sure you are using the correct harnesses, sensors and modules for the PCM you have installed. The PCM has to get a crank signal before it will turn on the fuel pump - other than the 2-3 second prime at key up.
SinisterX is offline   Reply With Quote
 
Page generated in 0.79948 seconds with 20 queries