Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Yj wiring with v8
View Single Post
Old April 21st, 2014, 08:53 PM   #1
masterbeatty
Senior Member
 
masterbeatty's Avatar
 
Join Date: 03-04-08
Location: my house
Posts: 4,161
iTrader: (17)
Mentioned: 4 Post(s)
Default Yj wiring with v8

Ok so I bought a manual and I've been staring at this thing, harness is a 95. I'm putting a carbed big block ford in it. For some reason I'm running the struggle bus. I need to supply a trigger wire to my starter relay. I need power for lights, wipers, I think that's it. I feel like I'm over thinking all this. Out of my harness to the fuse box on the pass fender what wire do I need to pull for a starter relay. Now lights and everything body should be run off what I have like it normally would if it had a 4.0 I'd assume. So I shouldn't have to touch that. My distributer should just need a hot lead correct?
masterbeatty is online now   Reply With Quote
 
Page generated in 0.04495 seconds with 20 queries