Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Bender Build...
Thread: Bender Build...
View Single Post
Old January 7th, 2007, 07:38 AM   #3
VonDirt
Senior Member
 
VonDirt's Avatar
 
Join Date: 08-10-06
Location: west side michigan
Posts: 629
iTrader: (19)
Mentioned: 0 Post(s)
Default

very cool

looking at the one you posted, (and its always hard to tell in photos) but having that single point to push from could spell trouble (green circle) the further it goes out in stroke. if there was a second location to push from it would help cylinder life (red arrow)

mine has about 7 or so notches to work from which i think is too many really. i only use 2 or three for 180's and most bends dont require that i move it at all.

also, a set of locking casters is a great thing since some pieces might hit your ceiling as your working (indoor outdoor option). it seems like im always moving mine and its way heavier than it looks.

VonDirt is offline   Reply With Quote
 
Page generated in 0.05661 seconds with 20 queries