Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Bender Build...
Thread: Bender Build...
View Single Post
Old January 6th, 2007, 11:05 PM   #1
Covered in mud...
Haggar's Avatar
Join Date: 11-06-05
Location: Oxford, MI
Posts: 17,914
iTrader: (59)
Mentioned: 9 Post(s)
Default Bender Build...

Not started yet, but over the next weeks weeks or so, I'll be building a hydraulic tube bender.

The good-old pipe bender has worked ok up until now, but I'd like something better, and fully automatic.

So, I'l be building a version of this one here, which people seem to have good luck with:

My goal is to get a air powered hydraulic ram and use that for the cylinder, as many have done on that thread.

Anyway, I'll post up when I've made some progress. Once its build, I'm thinking of making some dies myself, for some specialty applications.

At first, though, I'll buy at least one die, probably a 1.75" 6" CLR 240*
Haggar is offline   Reply With Quote
Page generated in 0.06104 seconds with 21 queries