Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 2001 rm125 basket build
View Single Post
Old March 25th, 2014, 08:51 PM   #6
Stranger Danger
koochman450r's Avatar
Join Date: 03-13-08
Location: New Boston MI
Posts: 2,907
iTrader: (26)
Mentioned: 1 Post(s)

Originally Posted by kixx007 View Post
Not a bad deal. I had a YZ125 like this a couple years ago.

Did you open the motor and only do one crank bearing? I'm confused. you said it needed crank bearings, but now you need to open it back up and do the crank bearing you were told was good?
Yes I did one crank bearing. Didn't have a flywheel puller. Crank spun fine, was told it would be fine. Never messed with 2 strokes much. So I did the clutch side that was locked up. Reassembled. Ran good for a little while. Now its got a growling hollow sound. Ordered a flywheel puller. Gonna do it in the next week or so. Once I get the gaskets I'll reassemble engine.
Originally Posted by clarkstoncracker View Post
you won this battle.
koochman450r is offline   Reply With Quote
Page generated in 0.05669 seconds with 21 queries