Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 4.5 stroker
Thread: 4.5 stroker
View Single Post
Old February 25th, 2014, 03:20 PM   #20
hoyt5885
Senior Member
 
hoyt5885's Avatar
 
Join Date: 01-18-10
Location: St.helen,Michigan
Posts: 1,170
iTrader: (17)
Mentioned: 1 Post(s)
Default

i have 200 in a cam and lifters and i am running 93 right now have not tried running 87-89 yet. i have 200 in boring the block, instaling new cam bearings and hot tanking the block. 150 in the head which incudes valve job and decking the head to insure it was straight. 200 in the cank that was turning it to .10 to .10 on main and rod journals and makeing sure it was straight. 80 in injectors from ebay 200 for pistons,rings,and cam bearings. 100 in main and rod bearings and 90 in a oil pump. if u are gonna do a rebuild i would most defintly put new cam bearings in it. if i wereto do it all over again i would save the moiney fro the stroker and just go 5.3 in it. or find a good running 4.0
hoyt5885 is offline   Reply With Quote
 
Page generated in 0.05365 seconds with 20 queries