Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - narrowed 9in 44 combo for xj
View Single Post
Old January 29th, 2014, 12:48 PM   #9
93yj06unlimited
Senior Member
 
93yj06unlimited's Avatar
 
Join Date: 06-02-09
Location: Scotts, Mi
Posts: 493
iTrader: (4)
Mentioned: 0 Post(s)
Default

I have a 44 front and a 9" rear with Moser chromoly shafts, 5.89 gearing, narrowed to 60.5". the front has all new spindles, spindle bearings and seals, new spindle locknuts and washers, new wheel bearings and seals, new stainless lockouts, and one new outer shaft with an older one that could be used as a spare. Both axles are 5x5.5 with disc brakes. I put a D60 and 14 bolt in place of them as I have 42/14/15 Iroks. $1000 will buy the complete setup. Also have outer axle seals to keep the crud out of the axle tubes. Front is welded not sure about the back. I was told when I bought it the back was spooled and the front had a Detroit in it but found the front to be welded so I can't positively vouch for the rear being spooled. The front is driver side drop also.
93yj06unlimited is offline   Reply With Quote
 
Page generated in 0.04917 seconds with 20 queries