Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - CJ NT D44 question
View Single Post
Old December 26th, 2006, 03:10 PM   #2
shawn
Resident HVAC/R Jambi
 
shawn's Avatar
 
Join Date: 11-05-05
Location: Milford/Commerce
Posts: 10,141
iTrader: (24)
Mentioned: 14 Post(s)
Send a message via Yahoo to shawn
Default

Looks like an open carrier to me.

But, if you are talking about the axle shaft bearings, I am pretty sure they should be tapered roller bearings, that are pressed on and then pressed on after that are the "wedding ring." Those are not C-clip, so they shouldn't have ball or straight drum roller style bearing, it should be a tapered roller bearn, and the outer race should be in the end of the axle tube.
shawn is online now   Reply With Quote
 
Page generated in 0.04276 seconds with 20 queries