Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Kyle M. Ranger Truggy, rebuilt again - Revision 4
View Single Post
Old November 5th, 2013, 08:46 AM   #2429
feva4u's Avatar
Join Date: 04-01-07
Location: Caledonia, MI
Posts: 10,671
iTrader: (12)
Mentioned: 20 Post(s)

Originally Posted by Kyle M. View Post
Thanks guys, I'll consider that. I just like the stance of the truck now and the wheel base, so if I push the front axle forward the 6"- 8" I'd need to to fit the 4 link, the rear axle will have to move too and I'm not too keen on that look, the tires will be into the extended cab or close to it. We will see, maybe I'll just 3 link it and keep it where it all is.

Erin, I'd like to borrow them at the very least to see what I need. I haven't searched anything yet.
When you get to that point set it on a set of springs with a known spring rate and use this:
Moog Spring Excel Sheet for Coil Spring Selection - Great Lakes 4x4. The largest offroad forum in the Midwest

Or just call me like everyone else does
My Jeep

Last edited by feva4u; November 5th, 2013 at 09:28 AM.
feva4u is offline   Reply With Quote
Page generated in 0.19562 seconds with 23 queries