Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - usa standard ford 10.25
View Single Post
Old October 25th, 2013, 07:12 AM   #6
bigbchevy
missmrgreenagain
 
bigbchevy's Avatar
 
Join Date: 09-15-07
Location: fenton /hartland mi
Posts: 19,686
iTrader: (167)
Mentioned: 78 Post(s)
Default

Quote:
Originally Posted by jbeery78 View Post
Not the outer.... I know the inner is a press fit... this is an awful long way to press a bearing. Plus once I slide the pinion yoke on there isn't near enough thread to pull it down.

Having trouble uploading pics on the phone I'll try it at work this morning.

My old pinion is a slip fit on the outer... as is every other one I've done... not sure what happened on this one though.
most every axle I have ever geared you have to (press) the outer on as well. what I do is put the pinion in the housing slide the new outer bearing in with crush sleave or shims if needed and have someone with a long 4x4 hold pressure on the pinion while you use the yoke and a brass hammer to press it on
__________________
H.o.r.e
(mr.green)So you are calling CC a liar?? Not a nice way to treat your bitch.
tube bending and gear installs pm me for info! gears installed for $150 and up per axle.
bigbchevy is online now   Reply With Quote
 
Page generated in 0.05449 seconds with 20 queries