View Single Post
Old October 25th, 2013, 05:20 AM   #1
jbeery78
Member
 
jbeery78's Avatar
 
Join Date: 09-26-12
Location: Leslie, MI
Posts: 75
iTrader: (1)
usa standard ford 10.25

Just got my new rear end gears this week, USA standard 5.38s for the sterling in my 78. Getting ready to set up, I noticed the outer pinion bearing won't slip down far enough... like the pinion is only machined for a slip fit to the base of the yoke spline. At least 4+5 thou difference. Anyone ever run into this, was gonna give a call to Randys R&P this morning hope this gets taken care of.

Is this what I get for being a cheap ass?? Maybe I ought to just send these back and get yukons.
jbeery78 is offline   Reply With Quote
 
Page generated in 0.04755 seconds with 11 queries