Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 7.3 super duty oil pan
View Single Post
Old October 20th, 2013, 09:56 AM   #11
Senior Member
tom77cj5's Avatar
Join Date: 03-06-06
Location: chesterfield
Posts: 4,028
iTrader: (41)
Mentioned: 2 Post(s)
Send a message via AIM to tom77cj5

Originally Posted by junk90xj View Post
I pull the trans, lift the motor up and the pan slides right out. Easiest way to do it IMO.

Pulling the motor or pulling the cab takes a lot longer
The motor comes out in about 3hrs labor. Its actually pretty easy. You don't have to pull the cab. Take the front end off. Disconect the trans and support it. Pull motor out. Only pulled mine cause I blew the trans but while it was out I did a pan and head studs. Nice part is you can make it pretty while its out. I drove my truck for ten years and sold it for what I payed for it lol

Last edited by tom77cj5; October 20th, 2013 at 10:04 AM.
tom77cj5 is offline   Reply With Quote
Page generated in 0.11130 seconds with 22 queries