CJ7 Juggy (Pics Added 10/16)
Parting out my 1983 CJ7 Juggy. Parts for sale as follows:
-Passenger drop D60 from 1980 K30. 4.10 gears, detroit locker, hi-steer arms, king pin, GLO diff cover, new driver u-joint, new pads. Has mile marker hubs that both blew so I welded the internals together and they have worked without issue as a poor mans drive slug. Replace them if you like but they work fine as is. Comes with steering Sold
-14 bolt ff from same truck. 4-link brackets, truss, welded, disc brake conversion, new caliper (driver side), GLO diff cover, 4.10 gears, spare shafts, GLO pinion guard Sold
-SM465 trans (have 4) $125 each
-np205 t-case (have 3) $100 each
-205 JB conversion twin stick $60
-Warn HS9000i Winch is in great shape but PO hard wired remote(plug on remote has been cut). I removed remote and wired up in cab winch controls (included). I will also include remote if you want it. Sold
-3A Racing reclining bucket seats with 5-point harnesses. Seats are in decent shape with no rips but slightly faded $300 for all
-1983 CJ7 chassis. Has firewall, hood, cut fenders, grill. Back half of frame has been cut off and tubed. Full cage tied into frame and boat sides (not skinned yet). Front has beefed up leaf mounts and rear is set up for triangulated 4-link on coil springs. Front and rear winch mounts. Tubing is 1.75x.120 HREW. Has small block chevy motor mounts. Seat mounts tied into cage. Tilt steering column and clutch/brake/gas pedals Sold
-1/2 soft doors in good shape. Small rip on driver side $40
-Full hard doors in good shape $80
I will add more stuff to this list as I sort through everything. Pics to follow.
Last edited by Mr.Jefferson; November 21st, 2013 at 08:18 AM.