Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - CTM U Joints...
Thread: CTM U Joints...
View Single Post
Old October 8th, 2013, 08:14 PM   #20
ReiKo
Community Smart Ass.....
 
ReiKo's Avatar
 
Join Date: 02-06-13
Location: Detroit
Posts: 727
iTrader: (3)
Mentioned: 3 Post(s)
Default

Quote:
Originally Posted by CheapThrillB2 View Post
I have always run non greasable spicers and have broke shafts but never the trunnions. If the precisions you mention are the ones Napa carry, they are junk. Broke so many of those. Just be sure to run the full circle clips on the joint to keep the caps on.
Those ones that Napa carry are sold by Precision but low quality made in China garbage... I was going to run Precision Super Strength... That's what I have in the 44 before I ripped all the ears off the drive side axle... And also because I can warranty them non-stop through my store without any problems...


I'm open to suggestions and appreciate all the info... Last thing I want is to be beating down on the truck and next thing I know I have a U-joint fail out in the middle of nowhere...

Last edited by ReiKo; October 8th, 2013 at 08:21 PM.
ReiKo is offline   Reply With Quote
 
Page generated in 0.04332 seconds with 20 queries