Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - DIY Control arms
View Single Post
Old October 4th, 2013, 07:53 AM   #18
Ringer
Newbie
 
Ringer's Avatar
 
Join Date: 09-26-13
Location: Chardon/ Oh
Posts: 2
iTrader: (1)
Mentioned: 0 Post(s)
Default

I built mine using 2"x.250" wall DOM with JJ at each end. I am redoing my rear 3 link this winter to a DT4, and will be using hex bungs this time to make tightening easier. I also do one RH and one LH thread on each arm to make them adjustable on the vehicle.
Ringer is offline   Reply With Quote
 
Page generated in 0.05432 seconds with 20 queries