Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - DIY Control arms
View Single Post
Old September 27th, 2013, 02:13 PM   #3
littletrucker
I'd hit that
 
littletrucker's Avatar
 
Join Date: 09-15-10
Location: Bear Lake 49614
Posts: 1,570
iTrader: (5)
Mentioned: 0 Post(s)
Default

Im running 2x.250 DOM 2X.375 is availible. For what you need 1.75x.120 would be more than enough.. I Have a few diffrent end joints on my jeep, but I like the johhny joints the best. you can get them to fit where a stock jeep bushing was at.

For what you are doing somthing like this would be good.. Weld on johhny joints on one end, threaded ones on the other. OR you could just make them weld on both ends.

http://www.4wd.com/Fabrication-Tools...n=CURCE-9110P#
littletrucker is offline   Reply With Quote
 
Page generated in 0.05177 seconds with 20 queries