Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Need help identifying drive slugs from my Dana 44
View Single Post
Old September 22nd, 2013, 06:23 PM   #18
BigBird
Duck Shootin' Wheelerer!!
 
BigBird's Avatar
 
Join Date: 07-17-08
Location: Soo, Ontario
Posts: 5,322
iTrader: (8)
Mentioned: 11 Post(s)
Default

Had to change the ball joints, that's why I was pulling the slugs. Found broken bolts, both sides. Pulled the slugs and found my 10 month old bearings absolutely fawked... Bought new bearings, and ball joints. Went to use ball joint press but could not get it to fit with high steer arm on. Clamped the arm in the vise and tried to get the bolts freed up. Powere bar with a length of pipe on it. Broke the base bolt on my vise... Had to fix the vise to remove the ball joint.

I think my jeep does not want to wheel in 10 days...
__________________
Cheap Thrills Off Road
BigBird is offline   Reply With Quote
 
Page generated in 0.04286 seconds with 20 queries