Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Project BS3.5 - Another Budget Samurai
View Single Post
Old September 17th, 2013, 09:18 PM   #33
Senior Member
kkodet's Avatar
Join Date: 01-21-07
Location: Marine City, Michigan
Posts: 5,022
iTrader: (47)
Mentioned: 6 Post(s)

After picking up the kids from school I spent some time finishing up the rear disc swap. I know this looks rough, but it is totally functional. This was also a "dry run" Idea and I may clean it up later. I followed the instructions as were posted in the earlier link. My only small modification/add to them was to tack weld the spacer washers (top of caliper bracket) because I could already see them falling out into the mud on the trail during a repair since they are sandwiched between the caliper and bracket. Now, rear shaft replacement is a 15-20 minute job tops, vs. an hour plus for original drum setups.

Last edited by kkodet; September 18th, 2013 at 07:01 AM.
kkodet is offline   Reply With Quote
Page generated in 0.17933 seconds with 22 queries