Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Welding Cast Iron Advice
View Single Post
Old September 3rd, 2013, 08:28 PM   #6
Senior Member
stuftmunky2k's Avatar
Join Date: 02-03-13
Location: broadway, ohio
Posts: 127
iTrader: (0)
Mentioned: 0 Post(s)

Ni rod is pretty easy to run just dont let the part cool down way to fast. ive also had really good success with tig welding cast with aluminum bronze filler wire. just dont forget grind all the gunk out thats possible and peen it after welding and keep fingers crossed it doesnt crack someplace else. welding cast is a luck of the draw type deal
stuftmunky2k is offline   Reply With Quote
Page generated in 0.16389 seconds with 22 queries