Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Welding Cast Iron Advice
View Single Post
Old September 3rd, 2013, 09:04 PM   #2
chadcooper55
expert jeep disassembler
 
chadcooper55's Avatar
 
Join Date: 08-28-08
Location: kent city mi
Posts: 8,055
iTrader: (20)
Mentioned: 12 Post(s)
Default

Sounds good you just need to preheat, peen with a punch after every pass and let it cool very slowly. Being that small of a piece I would wait til the wife isn't around and preheat in the oven and put it back in the oven after you are finished and slowly bring the temp back down.
chadcooper55 is offline   Reply With Quote
 
Page generated in 0.05645 seconds with 20 queries