Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My Early Bronco build
View Single Post
Old August 19th, 2013, 08:28 PM   #28
Senior Member
frdboy's Avatar
Join Date: 07-16-13
Location: Grand Haven
Posts: 13,796
iTrader: (0)
Mentioned: 5 Post(s)

Started on fixing the steering tonight and also wanted to check out the front end as 4x4 did not seem to work. Turning one side locked in nothing else turned. Pulled the cover to investigate and everything looked fine, even found a trac-loc in there. Long side shaft was spinning on the inside but not at the other end. Damn 44 shaft is broke already I haven't even wheeled it yet, I think it is a sign...

Still plan on fixing the shaft, steering and radius arm bushings so I can drive this thing a little.

frdboy is online now   Reply With Quote
Page generated in 0.10297 seconds with 22 queries