Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Carburator rebuild
View Single Post
Old August 3rd, 2013, 09:39 AM   #2
I'm not old, honest...
whiterhino's Avatar
Join Date: 03-07-06
Location: Davisburg MI
Posts: 27,325
iTrader: (24)
Mentioned: 131 Post(s)

When you take it apart, make sure you know where each adjustment screw was at. IE, idle screw, turn it in half turn at a time till it lightly bottoms out. Usually about 1 1/2 turns. Make sure when you put it back together it's the same. Everything else is just plug & play replacement. Make sure it's clean and you put the new parts in where the old ones came out. You'll be good to go.
whiterhino is offline   Reply With Quote
Page generated in 0.14579 seconds with 22 queries