Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Chevy Dana 44 Cut & Turn For Scout
View Single Post
Old July 14th, 2013, 10:42 PM   #12
Jeepaholic
Axle Guru Extraordinaire
 
Jeepaholic's Avatar
 
Join Date: 04-08-06
Location: Owosso
Posts: 7,323
iTrader: (116)
Mentioned: 2 Post(s)
Send a message via AIM to Jeepaholic Send a message via MSN to Jeepaholic
Default

5-7 degrees toward the rear. Caster comes before pinion angle when dealing on a front axle. So if pinion is bad then a cut and turn is needed. You will also need to use shims (not the best) or mill/grind the spring perch on passenger side and relocate the driver side
Jeepaholic is offline   Reply With Quote
 
Page generated in 0.05637 seconds with 20 queries