Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Chevy Dana 44 Cut & Turn For Scout
View Single Post
Old July 14th, 2013, 06:09 PM   #7
chadcooper55
expert jeep disassembler
 
chadcooper55's Avatar
 
Join Date: 08-28-08
Location: kent city mi
Posts: 8,030
iTrader: (20)
Mentioned: 10 Post(s)
Default

Quote:
Originally Posted by Carbon View Post
Front axle bolted right it just need to get my pinion angle right and fab up shock mounts. Rear is under the truck. Need to pick up some spring perches as the 3/4 ton springs sat out a bit further. Next ill be building custom drive shafts.
I don't know if I am reading wrong but I would be more worried about getting your caster correct with your front axle than your pinion angle unless you are going to grind the welds off the inner c's and rotate them to get it right.
chadcooper55 is offline   Reply With Quote
 
Page generated in 0.04593 seconds with 20 queries