Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Under Coating Removal Disc & Paint Stripping Discs...cleans & preps metal
View Single Post
Old June 26th, 2013, 12:03 PM   #8
Abrasive Trader
Black Foot
Abrasive Trader's Avatar
Join Date: 06-28-11
Location: Between the Bridge and Ohio
Posts: 130
iTrader: (1)
Mentioned: 0 Post(s)

Here's a couple more pics from the welding table clean-up. Some of these rust spots were took a lot of pressure to bring the surface back to life.

I was trading up with the flap disc in certain areas but it would work good and then load up. The paint stripper disc did load a little bit but stripped the most volume in the shortest time

Here a profile of the table edge caked with some paint. You could feel the chips hitting my feet along with some of the disc material!

This was after about 20 min of grinder time. Getting closer but that rust in the far right corner is tough.
Use Discount Code:::: GL4X4
Abrasive Trader is offline   Reply With Quote
Page generated in 0.90712 seconds with 21 queries