Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Help changing door hinge
View Single Post
Old June 19th, 2013, 07:15 PM   #2
vwbugg2275
Member
 
Join Date: 04-25-13
Location: dansville mi
Posts: 30
iTrader: (0)
Mentioned: 0 Post(s)
Default

don't need to have welder drill out the hole just big enough to make it round get a bigger bushing that fits the hole and then put the hinge pin bushing inside the new bushing just get a flared bushing (check with Fastenal) they have weird things like that or just like I said use over size bushing and put a couple of roll pins in the hinge pin to hold over sized bushing in one on top and one under neith the upper and lower hinge (4 total roll pins
vwbugg2275 is offline   Reply With Quote
 
Page generated in 0.05157 seconds with 20 queries