Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My TJ401 Build THREAD IS Now Back Open For Bidness!
View Single Post
Old June 12th, 2013, 06:11 PM   #110
Got rocks?
green50gt's Avatar
Join Date: 04-16-08
Location: Goshen, IN 46528
Posts: 3,514
iTrader: (60)
Mentioned: 9 Post(s)

Ok then. First off let me say that from my own personal experience - I couldn't have pulled off factory fenders & that size tire and lift without pushing the front axle forward. I have all 8 adjustable arms - IIRC I pushed the front forward 1", rear 3/4". Also I have/had quite a bit of bumpstop.

Also I have to apologize, I dont have any pictures of it flexing with the front flares on, but hopefully this gives you an idea. Hockey puck on the bottom, like 1" extended bumps on top. Oh and I had cut 3/4" out of the Rubicon flares.

Here is how it sat normally..

Here are the Rokmen highlines. I have the hockey pucks removed, and could probably remove the extended bumps as well as I have a smidge of room to to work with.

And how it sits normally..

Hope that helps!
I heart Jeeps
green50gt is offline   Reply With Quote
Page generated in 0.14373 seconds with 22 queries