Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mr. Beefy's "not quite yet U4 buggy" build
View Single Post
Old June 7th, 2013, 07:18 AM   #961
Big Block Ranger
bigblockford79's Avatar
Join Date: 05-11-08
Location: Hamilton, MI
Posts: 2,805
iTrader: (24)
Mentioned: 3 Post(s)

Were you running the complete F250 brake system on the last rig? Nothing removed?

Reason I ask is because of the proportioning valve. Its the one item that you haven't stated you are using in the new setup that would have been in the old setup unless you removed it.

Without it the fluid and pressure gets split 50/50 between the front and rear calipers. Which would cause your issue.
NOT sent from an iPhone
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!

"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
bigblockford79 is offline   Reply With Quote
Page generated in 0.13199 seconds with 22 queries