Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - CJ: Welding an engine block
View Single Post
Old June 3rd, 2013, 08:22 AM   #12
willdorf
Dude VonDudenstein
 
willdorf's Avatar
 
Join Date: 02-10-11
Location: Croton, MI
Posts: 321
iTrader: (1)
Mentioned: 0 Post(s)
Default

Thanks for all the advise guys. Does anyone have any specific specs for the rods? Like what numbers and stuff? Just want to make sure I get the correct amount of nickel and what not so it is a good weld and will hold for a bit. Granted this jeep is my toy, but I don't want to be redoing it. And it is cracked below the exhaust manifold, far enough down to just have to pull off the fender and the exhaust to get to it. Made the mistake of leaving water in it over the winter.
willdorf is offline   Reply With Quote
 
Page generated in 0.05985 seconds with 20 queries