Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - TTB U-joints
Thread: TTB U-joints
View Single Post
Old December 9th, 2006, 09:40 PM   #6
Stuck like a MoFo
mooseracing's Avatar
Join Date: 10-12-06
Location: South GR
Posts: 385
iTrader: (3)
Mentioned: 0 Post(s)
Send a message via AIM to mooseracing

Originally Posted by chris1044 View Post
And the inner U-joints DO go bad....I dont see why people are so damn afraid of replacing these - they are not that hard to do, especially if you're good with a torch
Everyone i have replaced haven't had any needles left in them. Like was stated take a torch and cut the center out. Easy and quick.

Since i have mad skills to remove the spindle i used a block a wood and big hammer and work my way around the spindle to knock it loose. Before reassembly clean the rust off the lip and coat with antiseize. Also buy a spindle bearing kit. I haven't seen one yet that the spidnle bearings weren't trashed.
mooseracing is offline   Reply With Quote
Page generated in 0.12369 seconds with 22 queries