Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Ramcharger Dana 44 help
View Single Post
Old May 15th, 2013, 09:57 PM   #1
jmgracing
Member
 
jmgracing's Avatar
 
Join Date: 09-12-08
Location: monroe
Posts: 34
iTrader: (0)
Mentioned: 0 Post(s)
Default Ramcharger Dana 44 help

Hey guys im hoping someone can help. I have a bog Sunday and need my truck going. I have a 1993 Ramcharger with the CAN Dana 44 with the 2 piece axle shaft. Something happened and my spider gear grenaded. Took my carrier out, went to the junk yard and found the same carrier from at 87 Ram. Swapped my gear on to the carrier (i had 3:55 junk yard was 3:24) put it back together and its so tight i cant fit any shims and something.is not right because the ring gear is not setting into the pinion gear
Its barely catching. Any ideas or suggestions are greatly appreciated!
jmgracing is offline   Reply With Quote
 
Page generated in 0.28770 seconds with 20 queries