Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - TTB U-joints
Thread: TTB U-joints
View Single Post
Old December 9th, 2006, 03:37 PM   #4
Jeeperz Creeperz
GL 4x4 Vendors
Jeeperz Creeperz's Avatar
Join Date: 11-08-05
Location: Wyandotte, MI
Posts: 3,148
iTrader: (13)
Mentioned: 2 Post(s)
Send a message via ICQ to Jeeperz Creeperz Send a message via AIM to Jeeperz Creeperz Send a message via MSN to Jeeperz Creeperz Send a message via Yahoo to Jeeperz Creeperz

Originally Posted by canaert View Post
i know ( DONT KNOW WHY I ASKED ABOUT BALL JOINTS) the ball joints have to have the kunchle come off the beam but we really need to know how in the Hell to get the damn Spindle off the knuckle no to pull the shafts
Take off the rotors, take off the 6-nuts on the spindle and tap it loose with a soft-faced hammer (brass, plastic, wood). Then pull the shafts out.

You'll need to remove the clamp for the boot on the inner slip shaft and pull the shaft out of the boot. You can just slide it back in and reinstall the clamp (with some careful reworking of the clamp). The inner u-joint hardly ever goes bad.
Jeeperz Creeperz, Inc.
1627 Eureka Rd
Wyandotte, MI 48192
M-F 10am-7pm
Sat 10am-3pm
Jeeperz Creeperz is offline   Reply With Quote
Page generated in 0.13259 seconds with 22 queries