Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - LQ4J: A 6.0 TJ DD on a budget
View Single Post
Old May 6th, 2013, 08:54 PM   #10
High Center Hancho
rack tap re-rack click
 
High Center Hancho's Avatar
 
Join Date: 07-10-07
Location: Genesee County
Posts: 13,235
iTrader: (40)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by Dannn View Post
we'll just consider the front a roller... i have no doubt that i will break it on the first drive. trying to figure out what axle will fit. i don't want full widths on a dd, and i'm not spending 1500 on a rubi 44.

The 231c... free. 6 bolt hex to 5 bolt transfer case adapter, free. np231J for parts, free. Its all stuff i had laying around, might end up grabbing a 241c later this week but not sure yet.

If it blows up, then it blows up... who cares? If the motor blows, i'll build it up. If the trans blows, i'll get a 4l80e and swap that in. I've been collecting free parts for the past 2 years, so i don't have much into this project. Benefits of working at a shop and digging through the scrap bin.
A rubi 44 won't hold any better than the Dana 30
High Center Hancho is offline   Reply With Quote
 
Page generated in 0.04973 seconds with 20 queries