View Single Post
Old May 6th, 2013, 07:27 PM   #9
Dannn
...
 
Dannn's Avatar
 
Join Date: 09-13-08
Location: Armada, Michigan
Posts: 398
iTrader: (1)
Quote:
Originally Posted by feva4u View Post
You can't build the front D30 to hold up to the power of the 6.0L, have fund spending thousands or driving like a puss to prove me wrong
we'll just consider the front a roller... i have no doubt that i will break it on the first drive. trying to figure out what axle will fit. i don't want full widths on a dd, and i'm not spending 1500 on a rubi 44.

The 231c... free. 6 bolt hex to 5 bolt transfer case adapter, free. np231J for parts, free. Its all stuff i had laying around, might end up grabbing a 241c later this week but not sure yet.

If it blows up, then it blows up... who cares? If the motor blows, i'll build it up. If the trans blows, i'll get a 4l80e and swap that in. I've been collecting free parts for the past 2 years, so i don't have much into this project. Benefits of working at a shop and digging through the scrap bin.
Dannn is offline   Reply With Quote
 
Page generated in 0.04204 seconds with 11 queries