here's all the parts that come with it, 1 ton steering, pan hard parts, coil springs, buckets, etc. basically everything needed for the suspension aside from shocks.
I keep getting asked this in a round about way so I'll explain it here, for the most part the pieces you need to buy to complete this project (and do it right) would be;
rear shackles (stock could work)
jeep slip yoke eliminator
jeep driveshafts and conversion joints
ford f150 brakes
I have stocks, for an F150, but they're stock replacement shocks, so i havent fit them to check, buyer is welcome to them though.
front and rear 5.14ish gears
exhaust pipe, or not, up to you! ;)
all in all, it's not much cash from completion. I'm too busy with my other two monteros, my two 70's dodges, my cafe project, my girlfriend and work. This project has always been kind of on the 'back burner' and it's becoming obvious that I'm not getting anywhere with it in a timely manner.